- Sun Joe Spx3000 Pressure Washer
- Snow Joe Spx3000 User Manual
- Sun Joe Spx3000 User Manual
- Sun Joe Pressure Washer Spx3000 Manual
- Sun Joe Spx3000 Problems
15
The Sun Joe SPX3000 is the #1 BEST SELLER in the USA. 2030 PSI, 1.76 GPM, 14.5 amps of cleaning power.FREE SHIPPING AVAILABLE. Snow Joe SPX3000 Pressure Joe 2030 PSI 1.76 GPM 14.5-Amp Electric Pressure Washer User Manual. Troubleshooting, Problems possible cause possible solution. Snow Joe Water equipment. View and Download Sunjoe SPX3000 operator's manual online. 2030 PSI/1.76 GPM Electric Pressure Washer. SPX3000 Pressure Washer pdf manual download. Also for: Pressure joe spx3000. The Sun Joe SPX4000 Electric Pressure Washer w/ Pressure Select is #1 TOP RATED. 2030 PSI, 1.76 GPM, 14.5 amps of power.FREE SHIPPING AVAILABLE.
Troubleshooting
• Disconnect the unit from the electrical power supply before carrying out maintenance on the machine or when checking that
its parts are in proper working order.
• To avoid unnecessary hassles, consult the following table before contacting customer service with any mechanical issues.
Problems
Possible Cause
Possible Solution
Machine refuses
to start
• Power failure/machine not
plugged into a working receptacle.
• Defective socket.
• Fuse has blown.
• Defective extension cord.
• Check to make sure machine is plugged into
a working outlet.
Sun Joe Spx3000 Pressure Washer
• Check the power cord and reset the GFCI.
Try a different outlet.
• Replace fuse. Switch off any other machines
that are using the same circuit.
• Try the unit without an extension cord.
• Check the hoses and connections are airtight.
• Clean or replace valves/seals.
• Please call the Snow Joe
®
+ Sun Joe
®
customer
service center at 1-866-SNOWJOE (1-866-766-9563)
for assistance.
• Replace fuse. Switch off other machines using
the same circuit.
• Check that the mains voltage corresponds to
specification on the model tag.
• Leave the washer for 5 minutes to cool down.
• Clean the nozzle.
• Install a fuse with a higher amp rating than the
amp consumption of the machine. Try the unit
without an extension cord.
• Allow machine to run by holding the trigger until
regular working pressure resumes.
• Check that the water supply corresponds to the
specifications required.
• WARNING! Avoid using long, thin hoses
(minimum 1/2 in. diameter).
• Clean the nozzle.
• Clean the water inlet filter.
• Straighten out the hose to remove any kinks/blockages.
• Please call Snow Joe
®
+ Sun Joe
®
customer service
center at 1-866-SNOWJOE (1-866-766-9563) for
assistance.
• Wait for pump/hoses or accessories to thaw.
• Connect inlet water.
• Clean the water inlet filter.
• Clean the nozzle.
• Pump sucking air.
• Valves dirty, worn out, or stuck.
• Pump seals worn out.
• Fuse has blown.
• Incorrect mains voltage.
• Thermal sensor activated.
• Nozzle partially blocked.
• Fuse too small.
• Air in inlet hose.
• Inadequate supply of mains water.
• Nozzle partially blocked.
• Water filter blocked.
• Hose kinked.
• Pump/spray gun is leaking.
• Trigger mechanism is broken.
• Pump/hoses or accessories frozen.
• No water supply.
• Water inlet filter blocked.
• Nozzle blocked.
Fluctuating pressure
Snow Joe Spx3000 User Manual
Machine stops
Fuse blows
Machine pulsating
Machine often starts
and stops by itself
Machine starts, but
Sun Joe Spx3000 User Manual
no water comes out